Couple pics of my ongoing project. Got the new 5.7 hemi and 545RFE tranny installed, using the AEV kit I bought from Brain.

Looks like you got a good start with that, anxious to see it all come together. Props.

drooling....uncontrollably. Damn that's going to be nice!

Got it all done with everything put back together. I'm really happy with the way it turned out. I know I could not have pulled this off with out the kit from AEV. With the kit and a JK factory service manual I think just about anybody could pull this off. The hardest part for the diy'er is pulling the body off. As always though where there is a will there is a way.
Here is the finished product.






Last shot just shows the little bit of droop in the front. I put the 2" OME hd lift on before the motor swap



Also a short sound clip of it. The clip really does not do it justice.
http://www.vimeo.com/1912231

The motor they shoulda put in there in the first place...

It's nice to know that everything was a clean install.
It looks great. And I'm sure it sounds and performs awesome.
Jeep needs to have this as a factory option.

Thanks again
Tyler